Electrically heated vertical sterilizer is used for sterilization of surgical instruments dressing materials linen rubber, plastic material by means of saturated stream under pressure of 15 to 20 P.S.I. (adjusted) apart from health services it is also used in scientific research laboratories, educational institutions and universities. Sturdy double walled construction with boiler inner chamber made of stainless steel of 18 SWG sheet. Outer shell is made of mild steel finished with powder-coated paint.

The boiler and outer shell is provided with air insulation. Lid is made of stainless steel plate and is tightened all-around by wings nuts. Molded, joint less gaskets are made of

Neoprene rubber. Sterilizer is hydraulically tested up to 40 P.S.I.

Autoclaves are fitted with water level arrangements to indicate water position inside the boiler, pressure gauze, air/steam release cock, spring loaded safety valve which can be set at any selected point from 10 P.S.I, +_ 3 P.S.I and drain cock.

Supplied complete with cord and plug to work on 220 volt. 50 Hz. AC. supply.

Available in following sizes.

Dia x depth.                              Load                  

a) 250 x 450 mm.              1.5 K.W.                              

b) 300 x 500 mm.              2.0 K.W.                             

c) 350 x 550 mm               3.0 K.W.                    

d) 400 x 600 mm               4.0 K.W.                                 

OPTIONAL ACCESSORIES:                                               

a) Automatic Pressure cut-off switch                                 

b) Low water level cut-off device